| Manufacturer: Seagate | Model: ST19171WC | TD# 270242 |
| Interface... Ultra Wide SCSI | Formatted Capacity... 9,100 MB |
| Cylinders | 5273 | Heads | 20 | Sectors | Variable |
| Landing Zone | Cyl + 1 | Precomp | N/A | RWC Cyl | N/A |
| Encoding Method | PRML | Xfer/Mb | 40 | MTBF (Hr X 1000) | 1000 |
| Form factor | 3.5" | Novell Y/N | Y | Height | HALF |
| Power | N/A | Power (Idle) | 12.4W | Speed | 7200 |
| Avg seek (ms) | 8 | Cache | 512k | Mfg. Warranty | 5 YRS |
NOTE: Can also be operated according to
SCSI-1 and SCSI-2 protocols.
Copyright ⌐ 1996, 1997 Tech Data
Corporation
Configuration and Jumper Options
The SCSI ID for WC drives is normally set over the SCSI bus by the host system using connector contacts 39 (ID0), 40 (ID2), 79 (ID1), and 80 (ID3).
ST19171WC drives do not have internal terminators or any other way of adding internal termination to the drive. You must provide external termination to these drives when termination is required.
The default is parity check of the SCSI bus enabled. To disable this feature, install a jumper across pins 7-8 on J2.
The host system has complete control over motor start functions.
The host system has complete control over motor start functions.
Write Protect = On (disables writing) Jumper across pins 9-10
on J2.
Write Protect = Off (enables writing-default) no jumper.
[Main
Menu] [Hard
Drives] [Controllers] [Tape Drives] [Glossary]